When sizing the thermal management system of an industrial machine or electrical enclosure, increasing fan airflow may seem like the most straightforward way to reduce internal temperature. However, the relationship between airflow and cooling capacity is less intuitive than it might appear and deserves closer examination.
Thermal power, mass flow rate and cooling capacity
To understand the relationship between the amount of air moved and cooling capacity, it is useful to start with a fundamental principle: air removes heat from components and carries it out of the enclosure.
The cooling capacity of a forced ventilation system therefore depends on the amount of heat that the air can remove per unit of time, which in turn depends on both the mass of air moved and the temperature difference between the incoming and outgoing air.
As a first approximation, the thermal power carried by the air is described by the following equation:
P = ṁ · cp · ΔT
where ṁ is the air mass flow rate, cp is its specific heat capacity and ΔT is the temperature rise of the air as it passes through the enclosure.
This relationship helps explain why, under the same conditions, a higher mass flow rate allows more heat to be carried away while maintaining the same temperature difference. Similarly, if the amount of heat to be dissipated remains constant, increasing the mass flow rate reduces the temperature difference between the incoming and outgoing air.
However, this does not mean that doubling the airflow will halve the internal temperature of the enclosure.
The equation describes the heat carried by the air, but it does not, on its own, determine the temperature reached by the components. This also depends on the thermal resistance between hot surfaces and the air, airflow distribution inside the enclosure and the presence of hot spots. As air velocity increases, convective heat transfer generally improves, but the resulting reduction in component temperature is not necessarily proportional to the increase in airflow.
What factors affect cooling capacity?
In addition to the amount of air moved, other factors can significantly affect ventilation system performance.
One of these is air density. At the same volumetric flow rate, lower air density results in a lower mass flow rate and, consequently, a reduced capacity to carry heat. For this reason, proper design must also take installation altitude into account.
The internal layout of the enclosure also plays an important role. Filters, grilles and obstacles affect airflow velocity and distribution, which can never be completely uniform inside the enclosure. Components positioned close together or areas that are difficult for the air to reach or hot spots can therefore limit ventilation effectiveness.
Finally, the external air temperature must also be considered. When it approaches the desired internal temperature, ventilation gradually becomes less effective because the temperature difference driving heat transfer decreases.
How should fan speed be adjusted?
In light of these factors, running fans continuously at maximum speed is not necessarily the best strategy: it can lead to unnecessary energy consumption and more demanding operating conditions than required.
One solution is to adopt proportional ventilation, which is particularly useful in systems sized to deliver high airflow rates under the most demanding operating conditions. Rather than always running at maximum speed or relying on continuous on/off cycles, the fan can adjust its operation according to the actual thermal load.
This is the principle behind the Fandis SMF range of electronic controllers, which can modulate EC fan speed according to the detected temperature, helping optimise cooling performance and energy consumption.
Fan selection, therefore, should not be based solely on the maximum rated airflow, but on the application’s thermal requirements and actual installation conditions.
To support this assessment, Fandis provides a dedicated sizing software tool on its website, helping users identify the ventilation solution best suited to the characteristics of their electrical enclosure.